| DIMM | Displayed Value |
|---|---|
| No DIMM installed | 7808 KB |
| 8 MB | 16000 KB |
| 16 MB | 24192 KB |
| 32 MB | 40576 KB |
Memory errors might stop system operations, show error messages on
the screen, or hang the system.
Use the following procedure to isolate memory problems.
NOTE: Make sure that the DIMM card is fully installed
into the connector.
A loose connection can cause an error.
- Power-off the computer and remove the IC DRAM card from its slot (if installed).
- Press and hold the F1 key; then power-on the computer. Hold the F1 key down until the Easy-Setup screen appears.
- Select Test and press enter.
- Select Memory and press enter to run the memory test on base memory. If an error appears, replace the system board.
- Power-off the computer and reinstall the DIMM card, then power-on the computer. Verify the memory size, then test the memory. If an error appears, replace the DIMM card.
If memory problems occur intermittently, use the loop option to repeat the test. When the test detects an error, an error log is printed on the printer connected to the parallel port. See 'Error Log' for more information.
Back to
Please see the LEGAL - Trademark notice.
Feel free - send a 
for any BUG on this page found - Thank you.