Printer (SelectaDock II - III)
Test the printer by connecting it to the computer before
testing it on the SelectaDock Docking System.
- Make sure the printer is
correctly connected and is powered on.
- Run the printer self-test.
If the printer self-test does not run correctly, the problem is in
the printer. Refer to the printer service manual.
If the printer self-test runs correctly, connect the Tri-Connector wrap plug (P/N 72X8546) on the
parallel connector on the rear of SelectaDock Docking System and run the advanced
diagnostic tests to determine the failing FRU.
If the advanced diagnostic tests (with the wrap plug connected)
did not detect a failure, replace the printer cable.
If the diagnostic detected the error, replace the system board of the computer.
If the problem is not corrected, do one of the following:
Please see the LEGAL - Trademark notice.
Feel free - send a for any BUG on this page found - Thank you.