How to Disable the Passwords TP 600-2645
See > 'Password Combinations' for more information about passwords.
There are two passwords used at a typical customer site:
the power-on password and the supervisor password.
How to remove the Power-On Passwords:
If only the power-on password is set, do the following to remove the power-on password.
If both the power-on password and the supervisor
password are set, do the following to remove the passwords:
Supervisor and Hard Disk Passwords:
The supervisor password and the hard disk password (HDP) are security features that are used to
protect the system and the hard disk data from unauthorized access.
No overriding capability is provided. If only a hard disk password is set, obtaining permission from the password owner to
unlock the password is a prerequesite for running diagnostic tests and performing service.
If both supervisor password and hard disk password are set, you can enter Easy-setup by pressing the
Enter key or by entering the power-on password at the supervisor password prompt. In this
case, the Password, Start up, Network, and Initialize icons cannot be selected.
See 'Password Combinations' for more information about passwords.
NOTE: The supervisor password and hard disk password cannot be replaced if they are forgotton. If the
customer forgets the supervisor password, the system board must be replaced. If the customer forgets the hard disk password, the
hard disk drive must be replaced.
Please see the LEGAL - Trademark notice.
Feel free - send a for any BUG on this page found - Thank you.