Intermittent Problems (TP 600/600E - 2645)
Intermittent system hang problems can be
caused by a variety of reasons
that have nothing to do with a hardware defect, such as:
cosmic radiation, electrostatic discharge, or software errors.
FRU replacement should be considered only when
a recurring problem exists.
When analyzing the intermittent problem, do the following:
- Run the advanced diagnostic test for the system board in loop mode
at least 10 times.
- If no error is detected, do not replace any FRUs.
- If any error is detected, replace the FRU shown by the FRU code.
Rerun the test to verify that no more errors exist.
Please see the LEGAL - Trademark notice.
Feel free - send a for any BUG on this page found - Thank you.