Memory Checkout (TP 560Z - 2640)


Memory Checkout

EDO DIMM cards are available for increasing the memory capacity.

DIMM Displayed
Value
(32MB Base)
Displayed
Value
(64MB Base)
No DIMM card installed 32192 KB 64960 KB
8 MB
(not supported by 560Z)
40384 KB 73152 KB
16 MB 48576 KB 81344 KB
32 MB 64960 KB 97728 KB
64 MB 97728 KB 130496 KB


Memory errors might stop system operations, show error messages on the screen, or hang the system.

Use the following procedure to isolate memory problems.

NOTE: Make sure that the DIMM card is fully installed into the connector. A loose connection can cause an error.

See 'Running the Diagnostics' for details.

  1.  Power off the computer and remove the DIMM card from its slot (if installed).
  2.  Press and hold the F1 key, then power on the computer.
     Hold the F1 key down until the Easy-Setup menu appears.
  3.  Select Test and press Enter.
  4.  Select Memory and press Enter to run the memory test on base memory.
     If an error appears, replace the system board.
  5.  Power off the computer and reinstall the DIMM card, then power on the computer.
     Verify the memory size, then test the memory.
     If an error appears, replace the DIMM card.


If memory problems occur, use the loop option to repeat the test.
If the test detects an error, an error log will be printed on the printer connected to the parallel port.

See 'Displaying the Error Log' for more information.


Back to  Jump to TOP-of-PAGE

Please see the LEGAL  -  Trademark notice.
Feel free - send a Email-NOTE  for any BUG on this page found - Thank you.