1130 System Board (TP 560Z - 2640)


1130 System Board



Apply grease (0.2 grams) over the module.
Refer to .step 5, for the location of the module.

NOTE:
  1.  The system unit serial number must be restored when the system board is replaced.
     Select the option Set system identification on the maintenance diskette.
     The flash ROM on the system board contains the vital product data (VPD) - that is, the system unit serial  number, system board system number, and other computer-unique data.
  2.  Do not power off the computer when restoring the VPD.
     The system unit serial number label is attached to the base cover.

 

Step Size (Quantity) Torque
2 Hex stud screw, silver hex-head (6) 4kgcm
3 M2 x 3 mm, yellow pan-head (2) 1.5kgcm


When re-installing: Make sure you use the correct screw, and tighten it firmly to the torque shown in the table if you have a torque screwdriver. Never use a screw that you removed. Use a new one. Make sure the screw is tightened firmly (see 'Screw Tightening Information' if you do not have a torque screwdriver).

 

Step Size (Quantity) Torque
5 M2.5 x 4mm, black bind (4) 4kgcm


When re-installing: Make sure you use the correct screw, and tighten it firmly to the torque shown in the table if you have a torque screwdriver. Never use a screw that you removed. Use a new one. Make sure the screw is tightened firmly (see 'Screw Tightening Information' if you do not have a torque screwdriver).

Back to  Jump to TOP-of-PAGE

Please see the LEGAL  -  Trademark notice.
Feel free - send a Email-NOTE  for any BUG on this page found - Thank you.