2030 LCD Inverter Card
Step
Size (Quantity)
Torque
2
M2.5 x 3.0mm, brass flat-head (2)
3kgcm
When re-installing: Make sure you use the correct screw,
and tighten it firmly to the torque shown in the table if you
have a torque screwdriver. Never use a screw that you removed. Use a new one. Make sure the screw is
tightened firmly (see 'Screw Tightening Information' if you do not have a torque screwdriver).
Be careful of high voltage on the cable.
Connect the LCD connector firmly to the inverter card by lining them up straight:
Please see the LEGAL - Trademark notice.
Feel free - send a 
for any BUG on this page found - Thank you.