2040 LCD Cable and Hinges
NOTE: When re-installing, see below details.
Please see the LEGAL - Trademark notice.
Step
Size (Quantity)
Torque
1
M2.5 x 5.5mm, brass flat-head (2)
3kgcm
3
M2.5 x 5.5mm, brass flat-head (3)
3kgcm
When re-installing: Make sure you use the correct screw,
and tighten it firmly to the torque shown in the table if you
have a torque screwdriver. Never use a screw that you removed. Use a new one. Make sure the screw is
tightened firmly (see 'Screw Tightening Information' if you do not have a torque screwdriver).
When re-installing:
See the following figure:
If you are replacing the TFT panel, put a spacer (P/N 05K4658) on the left hinge as shown below.
Back to 
Feel free - send a 
for any BUG on this page found - Thank you.