Removing and Replacing Defective FRUs (WP z50 - 2608)


Removing and Replacing Defective FRUs



This section provides information on removing and replacing FRUs.


 
SAFETY Notices (MULTI-LINGUAL TRANSIATIONS)

See > Safety Notice 1
See > Safety Notice 3

Safety Notice 6

Before removing any FRU, place the WorkPad z50 into suspend mode, unplug all power cords from electrical outlets, then disconnect any interconnecting cables and remove the battery pack and backup batteries.

  -CAUTION- If all power sources are removed from the WorirPad z50, all data and applications will be lost. If the problem is considered a software problem stored on DRAM memory, approach the problem from that standpoint before removing all power sources.

  -Attention- The mainboard is sensitive to, and can be damaged
by, electrostatic discharge.

An electrostatic discharge   (ESD) strap (P/N 6405959) must be used to establish personal grounding.


Back to  Jump to TOP-of-PAGE

Please see the LEGAL  -  Trademark notice.
Feel free - send a Email-NOTE  for any BUG on this page found - Thank you.