Configuring Options (Server 330)



Configuring Options

Before installing a new device or program, read the documentation that was shipped with it. Reading the instructions helps you to determine the steps that are required for installation and configuration. The following list provides a preview of the actions that might be required to configure the server.
  1.  Run the Configuration/Setup utility  program and record the current configuration settings.

     See 'Starting the Configuration/Setup Utility Program'.

  2.  Start the EISA Configuration Diskette and:

    1.  Record the current settings.
    2.  Install configuration files (.CFG) and overlay files (.OVL).

      NOTE:   If a .CFG file did not come with the adapter,  see Configuration Files

     See Recording EISA Configuration Settings and 'Starting the EISA Configuration Diskette'.
  3.  Set jumpers or switches on the server system board.
  4.  Set jumpers or switches on the device.

     See the instructions that was shipped with the adapter.

  5.  Install the adapter in the server.
  6.  Install software programs.

     See the installation instructions that was shipped with the  software.

  7.  Resolve configuration conflicts.

     See 'Resolving Configuration Conflicts'

Back to  Jump to TOP-of-PAGE

Please see the LEGAL  -  Trademark notice.
Feel free - send a Email-NOTE  for any BUG on this page found - Thank you.