Power Supply (Server 315, 325)
Power Supply
NOTE:
Verify that the voltage-select switch is set for
the correct voltage.
If the voltage switch is set to the wrong position,
permanent damage might occur to the server when you power it on.
If the power-on indicator is not on, and the power-supply fan is not
running, check the power cord for proper installation and continuity.
If the power cord is OK, either the power supply is defective or a
defective device is causing the power supply to shut off. Check the
power supply voltages.
The power supply is rated at 250 watts. Too many devices (adapters
or hard disk drives) can cause power consumption to exceed 250 watts
and cause the power supply to shut down.
Remove adapters or devices to determine if this is the cause.
If the voltages are incorrect, replace the power supply.
If the voltages are correct, and the Symptom-to-FRU index does not solve
the problem, go to 'Undetermined Problems'
P1
-Lead Pin |
+Lead Pin |
Vdc Minimum |
Vdc Maximum |
5, 6 5 6 6 |
1 2 3 4 |
Power Good +4.8V +11.52V -10.8V |
+5.25V +12.60V -13.2V |
P2
-Lead Pin |
+Lead Pin |
Vdc Minimum |
Vdc Maximum |
1 2 2 2 |
3 4 5 6 |
-4.5V +4.8V +4.8V +4.8V |
-5.5V +5.25V +5.25V +5.25V |
P3
-Lead Pin |
+Lead Pin |
Vdc Minimum |
Vdc Maximum |
2 3 |
1 4 |
+4.8V +11.52V |
+5.25V +12.6V |
P4, P5, P6, P7, and P8
-Lead Pin |
+Lead Pin |
Vdc Minimum |
Vdc Maximum |
2 3 |
1 4 |
+11.52V +4.8V |
+12.6V +5.25V |
P9
-Lead Pin |
+Lead Pin |
Vdc Minimum |
Vdc Maximum |
3 |
1 |
+4.8V |
+5.25V |
Pin. |
Description |
2 |
- Power On Request |
4 |
EPW (No connection on system board) |
5 |
VFAN (No connection on system board) |
P10, P11
-Lead Pin |
+Lead Pin |
Vdc Minimum |
Vdc Maximum |
4 |
1 |
+3.3V |
+3.5V |
5 |
2 |
+3.3V |
+3.5V |
6 |
3 |
+3.3V |
+3.5V |
P12
-Lead Pin |
+Lead Pin |
Vdc Minimum |
Vdc Maximum |
3 |
1 |
+4.8V |
+5.25V |
Pin |
Description |
2 |
- Power On Request |
Back to
Please see the LEGAL - Trademark notice.
Feel free - send a
for any BUG on this page found - Thank you.