Preparing to Install Options

Preparing to Install Options

Before you begin: Read 'Safety Information'.

Note: You do not need to turn the server off to work with hot-plug or hot-swap devices, such as hot-plug PCI adapters, and hot-swap hard disk drives.

If you are:

  1.  Unlock and open the server door.

       When unlocked, the server door will not support  the weight of the server. To avoid personal  injury, be sure to remove or lock the server door  before moving or lifting the server.

  2.  Remove all media (diskettes, CDs, optical discs, or  tapes) from the drives, then, turn off the server and all  attached options.

       The Power Control button on the front of the  server does not turn off the electrical current  supplied to the server. The server also might  have more than one power cord. To remove all  electrical current from the server, ensure that all  power cords are disconnected from the power  source.

  3.  If you have a modem or fax machine attached to the  server, disconnect the telephone line from the  electrical outlet.
  4.  Unplug all power cords (cables) from electrical  outlets.
  5.  Note the location of the remaining cables and cords,  then disconnect them from the back of the server.

       Electrical current from power, telephone, and  communication cables can be hazardous. To avoid  personal injury or equipment damage, disconnect the  attached power cords, telecommunications systems,  networks, and modems before you open the server  covers, unless instructed otherwise in the installation  and configuration procedures.  Go to 'Top Cover Removal'.

Back to  Jump to TOP-of-PAGE

Please see the LEGAL  -  Trademark notice.
Feel free - send a Email-NOTE  for any BUG on this page found - Thank you.