Installing the Expansion Unit in a Tower Conversion Kit - EXP200 Type 3530 - 1RU, 1RX

Installing the Expansion Unit in a Tower Conversion Kit

The EXP200 Rack-to-Tower Conversion Kit provides an enclosure for a single EXP200 expansion unit.
Use the mounting hardware that comes with the EXP200 expansion unit to
install the unit in the enclosure as follows:

1.  Unlock and open the enclosure door.
2.  Turn the EXP200 expansion unit counter-clockwise onto its left side and slide it into the enclosure;  then, remove the white screws and wingnuts from the EXP200 bezel.
3.  Align the bezel locator pins with the expansion unit; then, secure the bezel and EXP200 with  black hex screws -1- on the top and bottom.
4.  Remove the two small screws from the rails that come with the EXP200 expansion unit; then,
    secure the rear of the expansion unit with the small screws -2- on the top and bottom.
5.  Verify that Option Switch 5 is set to On (see 'Setting the interface options' for further device settings).
6.  Install hard drives, fans, and power supplies in the EXP200 expansion unit.