Guidelines for the Rebuild operation

Guidelines for the Rebuild operation

•  General Information about the Rebuild Operation
•  Automatically Rebuilding the Defunct Drive
•  Software and Physical Replacement
•  Using and Understanding the ServeRAID Administration Log
•  Recovery From ServeRAID Adapter Failure

•  Recovery Procedures
  •  When HSP is Present at Time of Failure
  •  When HSP is Not Present at Time of Failure

•  The replacement hard disk drive must have a capacity equal to or greater  than the failed drive.
•  If the hard disk drive being rebuilt is part of a  RAID level-0 logical drive, the RAID level-0 logical drive is blocked.
  •  You must unblock any RAID level-0 logical  drives at the end of the rebuild operation.
  •  If you use the Administration and  Monitoring Utility to initiate the rebuild operation, you can unblock the  blocked RAID level-0 drive when the rebuild operation completes.

•  Data in a logical drive with RAID level-0 is lost  during the rebuild operation. If you backed up the data before the drive  failed, you can restore the data to the new drive.

Please see the LEGAL  -  Trademark notice.
Feel free - send a   for any BUG on this page found - Thank you.