Installing a U-Bolt and Security Cable

Installing a U-Bolt and Security Cable

You can help to deter unauthorized removal of the Netfinity 3000 server by installing a U-bolt and security cable on the rear of the server. After you add the security cable, make sure that it does not interfere with other cables that are connected to the server.

Note:

•  Obtain the following:
  •  A 19 mm (3/4 in.) U-bolt or wire rope  (similar to National Manufacturing No. 3230, Stock No. 176-735)
  •  Threaded nuts that fit the U-bolt
  •  A security cable
  •  A lock, such as a combination lock or padlock
•  Read Safety Information.

1.  Remove the server side cover  (see Disconnecting Cables and Removing the Side Cover).
2.  Locate the two holes on the lower right edge of the rear of the server.
3.  Insert the U-bolt through the rear panel; then, attach  and tighten the nuts with an appropriately sized or adjustable wrench.
4.  If you have completed installing the U-bolt and do not  want to install any other internal options, replace the  server side cover and reconnect all external cables  and power cords.  (See Completing the Installation  if you need additional information.)
5.  Thread the cable through the U-bolt and around an  object that is not a part of or permanently secured to  the building structure or foundation, and from which it  cannot be removed; then, fasten the cable ends together with a lock.

Please see the LEGAL  -  Trademark notice.
Feel free - send a   for any BUG on this page found - Thank you.