Working with drives in bays 5 and 6

Working with drives in bays 5 and 6

Notes:

•  Read Working with drives in bays 1 through 4.
•  Read the documentation that comes with the drive.

1.  Remove the screw that holds the drive bay assembly,  and carefully slide the drive bay assembly past the cover lock and out.
2.  If there is a hard disk drive in bay 6, disconnect the  cable from the drive in that bay. If there is a drive in  bay 5, disconnect its cable.
3.  If you are removing a drive, remove the screws that  hold the drive in the cage and slide the drive out of the cage.
4.  If you are installing a drive in bay 5, turn the drive  upside down before you slide it into the bay. This  ensures that the drive connector will align with and  attach properly to the cable connector.  When you install the four screws that come with the  drive, attach them to the drive from the top.  The following illustration shows a drive being installed in bay 5.
5.  If you are installing a drive in bay 6, turn the drive upside down before  you slide it into the bay. This ensures that the drive connector will align  with and attach properly to the cable connector. If the server comes with a  drive installed in bay 6, two screws are attached to each side of the drive  assembly. Therefore, if you remove a drive from bay 6 and install another  drive in that bay, use the screws that come with the preinstalled drive.

   Note:
    When using the rubber grommets (washers) to attach the drive to the rear  drive bay assembly, you must use the screws provided in the tray in bay 2.

6.  Reinstall the rear drive bay assembly and secure it with the screw  that you removed in step 1.
7.  Attach the cables to the drive, as shown in the following illustration.
8.  If you want to install or remove any other options, do so now.  Otherwise, go to Completing the Installation.

Please see the LEGAL  -  Trademark notice.
Feel free - send a   for any BUG on this page found - Thank you.