Configure/view host adapter settings

Configure/view host adapter settings

To view or change the SCSI controller settings, select Configure/View Host Adapter Settings and follow the directions on the screen.

Note: On this menu, the SCSI controller is referred to as the Host Adapter.

This menu has the following choices:

•  Host Adapter SCSI ID
   The default SCSI ID of the SCSI controller is 7. Do not change this value!
•  SCSI Parity Checking
   The default value is Enabled. Do not change this value!
•  Host Adapter SCSI Termination
   The default value is Automatic. Do not change this value!
•  Boot Device Options
   Select this choice to configure startable device  parameters. Before you can make updates, you must  know the ID of the device whose parameters you  want to configure.  The default startup (boot) SCSI ID is 0 for an internal  SCSI hard disk drive in Channel A.
•  SCSI Device Configuration
   Select this choice to configure SCSI device  parameters. Before you can make updates, you must  know the ID of the device whose parameters you  want to configure.

  Notes:

  1.  For SCSI tape drives, set Send Start Unit Command to Off  for that SCSI ID. This ensures proper server operation.
  2.  When the Maximum Sync Transfer Rate is set to 40.0, this value  represents the transfer rate for UltraSCSI devices. When this value is set to  20.0, it represents the transfer rate for Fast SCSI devices.

•  Advanced Configuration Options
   Select this choice to view or change the settings for  advanced configuration options. These options  include enabling support for large hard disk drives  and support for drives with UltraSCSI speed.

Please see the LEGAL  -  Trademark notice.
Feel free - send a   for any BUG on this page found - Thank you.