Installing the Files after Installing UnixWare

Installing the Files after Installing UnixWare

Use the following instructions to install the ServeRAID files after you install UnixWare, or use these instructions to update a previously installed ServeRAID file with a newer version.
You can use the UnixWare Pkgadd or the UnixWare SCOAdmin utility program to install the files.

Installing an HBA Diskette File Using Pkgadd

1.  Insert the IBM ServeRAID Device Drivers for SCO Operating Systems Diskette  into the diskette drive.
2.  Type:

     pkgadd -d/ dev/dsk/f0t

3.  Press Enter
4.  When the message Insert diskette into Floppy Drive 1 appears, press Enter.
5.  When the message Installation of IBM ServeRAID SCSI IHV HBA (ips) was successful appears, type:

     q

6.  Press Enter; then after the device driver installs, restart the system.

Installing an HBA Diskette File Using SCOAdmin

1.  Insert the IBM ServeRAID Device Drivers for SCO Operating Systems Diskette  into the diskette drive.
2.  Start the SCOAdmin utility program.
3.  Select Software_Management.
4.  Select Application Installer.
5.  Select Disk_A from the Install From tab.
6.  Click on the Update View button.
7.  When the icon labeled ips appears in the window, click on Install.
8.  After the device driver installs, restart the system.