Controller Reset Button
The controller reset button (see Figure 3) is used to produce a hard system reset.
The effect is the same as powering the tape library off and then on again.
When the reset button is pressed, the tape library enters the initialization/setup mode.
In the initialization/setup mode, the robotics calibrates the system and prepares to go on-line. This is useful for restarting a library that might have stopped in the middle of an operation, or to start the initialization routine so that you can enter the setup mode.
Simultaneously pressing the MENU, CYCLE, and SELECT control keys for approximately six seconds will also reinitialize the tape library.
For more information about the control keys, see 'Using the Control Keys'.