Using the Operator Panel to Change Modes


Using the Operator Panel to Change Modes

Use the following procedure to change the operational mode.

Note: Make sure the front door key lock is in the 12 o'clock position.


Starting from:

      IBM XXX7  X.XX x
      ONLINE
      A:  IDLE
      B:  IDLE

  1.  Press the CYCLE key once. The following menu is shown on the operator panel.

           ->CHANGE MODE
             MOVE CARTRIDGE
             DLT DIAGNOSTIC
             CONFIDENCE TEST
             REMOTE DIAGS
             DRVLDULD
             COMM TEST
             MAINTNANCE MENU
     

  2.  Press the SELECT key once. The following menu is shown on the operator panel.

          ->ONLINE
            OFFLINE
            DIAG OFFLINE
     

     Press the CYCLE key until the arrow is pointing at the desired operational mode.
     Press the SELECT key to set the tape library to the new mode.

     The tape library is now in the new operational mode.
     The operator panel shows the starting menu with the new operational mode on row 2.


Back to  Jump to TOP-of-PAGE

Please see the LEGAL  -  Trademark notice.
Feel free - send a Email-NOTE  for any BUG on this page found - Thank you.