Undetermined Problems - Netfinity 5600 - Type 8664
Undetermined Problems
You are here because the diagnostic tests did not identify the failure,
the Devices List is incorrect, or the system is inoperative.
Notes:
- If you suspect a software mismatch is causing failures (solid or intermittent), be sure to see
'Resolving configuration conflicts'.
- A corrupt CMOS can cause undetermined problems.
Check the LEDs on all the power supplies.
If the LEDs indicate the power supplies are working correctly, return here and do the following:
- Power-off the computer.
- Be sure the system is cabled correctly.
- Remove or disconnect the following (one at a time) until you find the failure
(power-on the computer and reconfigure each time).
- Any external devices
- External surge suppressor/UPS devices
- Modem, printer, mouse, or non-IBM devices
- Each adapter
- Drives
- Memory-Module Kits (Minimum requirement = 1 bank of 128 MB DIMM
- Secondary microprocessor VRM, if installed
Note: Minimum operating requirements are:
Power supply
Processor board, use switch 3 on switch block 2 on the processor board to bypass the power switch button.
Verify that the power connectors J11 and J14 are installed correctly at both ends.
System Board
Memory Module kit Minimum requirement = 1 bank of 128 MB DIMM
- Power-on the computer. If the problem remains, suspect the following FRUs in the order listed:
- Power Supply
- Processor
- System Board
- Processor Board
Note: If the problem goes away when you remove an adapter from the system,
and replacing that adapter does not correct the problem, suspect the system board then the processor.
Back to 
Please see the LEGAL - Trademark notice.
Feel free - send a 
for any BUG on this page found - Thank you.