6382/S, 6384/D and 6387/T Microprocessor Upgrade - Jumper
The following table contains the microprocessor upgrade jumper positions for ValuePoint 6382/S, 6387/T, and 6384/D (except P60) systems.
System Board
Installed Type 1 Type 2
Processor(s) J10 J11 J17 J18
-------------------- --------------------------
80486SX only R R R R
80486SX & 80487SX R R R R
80486SX & OVERDRIVE R R R R
80486SX & DX F F F F
80486SX & DX2 F F F F
80486DX only F X F X
80486DX2 only F X F X
OVERDRIVE only R R R R
80486SX & DX4 Overdrive (1) R R R R
DX4 OVERDRIVE only (1) R R R R
------------------------------------------------
R = Rear two pins (labeled OD and closest to I/O connectors)
F = Front two pins
X = Front or rear two pins
Microprocessors can be identified by the following
characteristics:
80486SX - Soldered to system board; no heat sink
80487SX - Intel® 80487 printed on heat sink
80486DX* - Heat sink without identification
80486DX2* - Heat sink without identification
IBM Overdrive - "IBM FRU P/N92F2582" printed on heat sink
Intel® Overdrive - "Intel® Overdrive" printed on heat sink
Intel® DX4 Overdrive (1) - "Intel® DX4 Overdrive" printed on heat
sink and an attached VRM - voltage regulator board.
Note 1: The IBM PCCO has not tested the Intel® DX4 Overdrive on these models. If problems are suspected with the DX4, refer customer to the point of purchase or Intel® support.
* Use the system Configuration Utility to differentiate the DX and DX2 processors.
Please see the LEGAL - Trademark notice.
Feel free - send a for any BUG on this page found - Thank you.