![]() |
P24T-25/63 P24T-33/83
Please see the LEGAL - Trademark notice.
< 9576i / 9577i Processor Upgrade Instruction
OVERDRIVE Processor Upgrade Table
P24T and DX/4 support P24T Overdrive Parts - Qualified
PODP5V63 PODP5V83
| |
YES = supported | |
N/S = Not-supported | |
ValuePoint II Series --------------------------------------------------------------
6382/S 6384/D | YES | N/S L6JT68A Flash BIOS required
25MHz clock | | No Interposer required.
| | Type 1 Planar Jumper 10 and 11 = OD
| | Type 2 Planar Jumper 17 and 18 = OD
| |
6382/S 6384/D 6387/T| N/S | YES L6JT68A Flash BIOS required
33MHz clock | | No Interposer required.
| | Type 1 Planar Jumper 10 and 11 = OD
| | Type 2 Planar Jumper 17 and 18 = OD
ValuePoint SI Series --------------------------------------------------------------
6381-SI /F /K | N/S | N/S
SX Boards | |
| |
6381-SI /W /M | N/S | YES L9JT42A Flash BIOS required.
DX Boards | | Interposer required
| | Origin Processor needs removed
PS/2 9576i 9577i -----------------------------------------------------------------
For more details see -> 9576i 9577i Processor Upgrade
PS/2 9576i 9577i | N/S | YES Diags Lvl. G7GT55A required
| | Interposer required
Models | | Set Jumper 3 to the 2 pins closest to processor
xUx - 486SX 33 | | (not to the SX position)
xNx - 486DX2 66 | | DX/4 - J19 remove Voltage Regulator (VRM)
xTx - 486DX4 100 | | Jumper pins 3-4, 5-6 and 7-8 (Pin 9 = blank)
ValuePoint HI Performance ---------------------------------------------------------
6472 6482 6484 6492| YES | YES LDJT70A Flash BIOS required
6494 | | Interposer required
| | *) see Note
Model | | Jumpers must be set properly
Kxx Cxx Hxx Lxx Xxx | | DX/4 - remove Regulator and
| | fit jumper block.
PC300 Series ----------------------------------------------------------------------
6571 6581 | YES | YES LEJT59A Flash BIOS required
| | Interposer required
Model | | *) see Note
Kxx Hxx Lxx Wxx | | Jumpers must be set properly
| | DX/4 - remove Regulator and
| | fit jumper block.
PCI Systems -----------------------------------------------------------------------
6573 6583 | NO | NO Supported as 6571 6581 if
| | Planar U28 is OPTI 82C802GA.
| | If U28 is 82C802G then planar
| | FRU P/N 96G1819 required.
----------------------------------------------------------------------------------
NOTE:
Using Part PODP5V63 Set J17 and J18 for 25MHz setting and J6 for non SL.
Using Part PODP5V83 Set J17 and J18 for 33MHz setting and J6 for non SL.
DX/4 - J11 remove Voltage Regulator - Add moulded 2x10 position jumper.
Back to
Feel free - send a for any BUG on this page found - Thank you.