NOTE: If you are not able to correct the problem using the IML and IPL Errors section, go to Undetermined Problems
Symptom/Error:
FRU/Action.
I999001X I999002X
1. Restore the System Partition. If you
I999003X I999004X
need assistance, see
(The actions for these errors are valid only
'Restoring the System Partition'
when running the system from the hard disk)
I9990053 I9990054
1. Restart the computer from the
I9990056 I9990057
Reference Diskette. If the same
I9990059 I9990063
error code appears, try new
I9990067 I9990069
System Diskettes.
(These actions for these errors are valid only
when running the system from the System Diskettes)
I999006X
1. Power-off the computer. Insert
the Reference Diskette, toggle the
override jumper, then power-on the
computer. Then restore the System
Partition. If you need assistance, see
'Restoring the System Partition'.
I999007X I999009X
1. Restore the System Partition.
(The actions for these errors are valid only
If you need assistance, see
when running the system from the System Diskettes)
'Restoring the System Partition'.
I99900X1 I99900X2
1. Restart the computer from the
I99900X3 I99900X4
Reference Diskette. If the same
I99900X6 I99900X7
error code appears, try new
I99900X9
System Diskettes.
(These actions for these errors are valid only
when running the system from the System Diskettes)
I99900X5
1. Power-off the computer, toggle the
(Reference Diskette recovery prevented)
power-on password override jumper
then power-on the computer.
I9990301
1. Cable failure
(Boot routine unable to read boot record.
2. Wrong Termination
This is probably a hardware failure)
3. SCSI Adapter/Controller
4. Hard Disk
I9990302
1. Install an operating system
(No operating system found on the default
2. Check for a valid selectable startup
SCSI hard disk)
sequence.
I9990303
1. Restore the System Partition.
The IML code did not load from the
If you need assistance, see
System Partition.
'Restoring the System Partition'
I9990304
1. No operating system installed.
(No startable device found. This error
2. Selectable startup sequence does
This error is on ASCII consoles only)
not contain the default drive.
I9990305
1. No operating system installed.
(No startable device found)
2. Selectable startup sequence does
not contain the default drive.
I9990306
1. Restart the computer from a
(Invalid startup. Trying to start from
startable diskette or hard disk drive.
a CD-ROM drive)
I9990401
1. System Board or Processor Board
(Unauthorized access. Type or erase the
NOTE: Whichever contains the system ROM
power-on password before replacing FRUs)
I9990402 I9990403
1. System Board or Processor Board
NOTE: Whichever contains the system ROM
I9990600 I9990607
1. Power-off the computer. Insert
I9990609
the Reference Diskette, toggle the
override jumper, then power-on the
computer. Then restore the
System Partition.
If you need assistance see
'Restoring the System Partition'
Please see the LEGAL - Trademark notice.
Feel free - send a for any BUG on this page found - Thank you.