63xx ValuePoint

  See also > POWER-ON PASSWORD removal

Type 6381 Computers

- All Models:

  1.  Remove the battery for 10 minutes.
  2.  Reinstall the battery.
  3.  Power-on the computer. The password is erased from memory.

Type 6384 Computers

- Model 325T:

  1.  Move the jumper on J8 so that it connects the center pin on the pin on  the opposite end of the connector.
  2.  Power-on the computer. The password is erased from the memory. (Leave  the jumper in that position until the next time you reset the password.)

- Model 425SX, 433DX and 466DX2:

  1.  Move the jumper on JP8 so that it connects pin 2 and 3.
  2.  Apply a momentary short across the two ends of capacitor C17.
  3.  Move the jumper on JP8 back to PINs 1 and 2. The password is erased from memory.
  4.  While holding down the mouse buttons, power-on the computer. Release the  mouse buttons when the cursor appears.
  5.  When you are finished servicing the machine, run the Configuration Utility  program to restore the configuration settings.

Type 6382/S 6384/D and 6387/T Computers

- Models 425SX/S 425SX/D 433SX/S 433SX/D
- 433DX/D 466DX2/S 433DX/T and 466DX2/D:

  1.  Move the jumper on J9 (type 1 system board) or J15 (type 2 system board), so that it  connects the center pin and the pin on the opposite end of the connector.
  2.  Power-on the computer. The password is erased from the memory. (leave the jumper in  that position until the next time you reset the password.)

Type 6384 P60/D Computers

- All Models:

  1.  Remove the battery for 10 minutes.
  2.  Reinstall the battery.
  3.  Power-on the computer. The password is erased from memory.

OR
(for a power-on and administrator password reset)

  1.  Move the jumper to the DIS position.
  2.  Reconnect the power cord, turn on the computer, and allow it to complete POST.
  3.  Turn off the computer.
  4.  Turn on the computer and use the config.-utility to enter a new password.
  5.  Turn off the computer (disconnect the power cord).
  6.  Move the jumper back to ENA position.
  7.  Reconnect the power cord and turn on the computer.

Back to  Jump to TOP-of-PAGE

Please see the LEGAL  -  Trademark notice.
Feel free - send a Email-NOTE  for any BUG on this page found - Thank you.