85xx PS/2

Type 85xx Computers

- Models 25, 30, 33, 35, 40, 56, 57, 76, 77 ,85, 90 and 95 Override Jumper:

The override jumper is located on the system board .

System	Jumper Location
Model 25 SX	J2
Models 25, 30 (286)	J13
Models 8535, 8540	J14
Models 8556, 8557	J18
Model 8590	J10
Models 9533, 9535	J20
Model 9540	J20
Models 9556, 9557	JMP1
Models 9576, 9577	JMP1
Model 9595 (Server 95)	JMP1
Server 85 Model 95	J16

1.  Move the jumper so that it connects the center pin on the pin on  the opposite end of the connector.
2.  Power-on the computer. The password is erased from the memory. (Leave  the jumper in that position until the next time you reset the password.)

- Models 55SX, 65SX Override Jumper

1.  Locate the speaker cable and the connector that it plugs into.
2.  Unplug the speaker cable, turn it over (180°), and plug it back in.
3.  Power-on the computer. The password is erased from the memory. (Leave  the jumper in that position until the next time you reset the password.)

- Models 50, 60, 70 and 80 Override Jumper

1.  If on the speaker assembly are two BERG pins, short this pins together  (with a jumper).
    If the speaker assembly does not have BERG pins, insert a meter lead into the  cable connector and short the other end of the lead to frame ground (Power supply).
2.  With the assembly shorted, power-on the computer. This erases the power-on password.  Remove the short after POST is finished.

- Models P70 and P75 (8573) Override Jumper

1.  Locate the two PINs nearby the SIMM (MEM 4) memory connector.
2.  Place a jumper (short) on this PINs.
3.  Power-on the computer. (The password is erased from the memory)
4.  Remove the jumper after POST is finished.

Please see the LEGAL  -  Trademark notice.
Feel free - send a   for any BUG on this page found - Thank you.