This is not an IBM Part. For information only.
Creative Labs Sound Blaster AWE32 - Location and Jumper
Base I/O Address (X = Jumper present)
This is not an IBM Part. For information only.
Creative Labs Sound Blaster AWE32 - Location and Jumper
Base I/O Address (X = Jumper present)
Secundary Tertiary
o o o o o o o o o o o o o o o o o o o o o o o o o
CD Connector CD_IN
Please see the LEGAL - Trademark notice.
I/O Baseaddress
I/O Addressrange
Advanced WavEffets Synthesizer
IOS0
IOS1
220H (default)
220H - 233H
620H - 623H
A20H - A23H
E20H - E23H X
X
240H
240H - 253H
640H - 643H
A40H - A43H
E40H - E43H
X
260H
260H - 273H
660H - 663H
A60H - A63H
E60H - E63H X
280H
280H - 293H
680H - 683H
A80H - A83H
E80H - E83H
MPU-401 - MIDI Connector (X = Jumper present)
I/O Baseaddress
I/O Addressrange
MSEL
300H
300H - 301H
330H (default)
330H - 331H
X
MIDI Connector (X = Jumper present)
MIDI Connector
MFBEN
Active (default)
X
Inactive
IDE CD-ROM - Ports (IDE SETTING) (X = Jumper present)
o o o o o o
| (default) |
o o o o o o
IDEIO
100
101
IDE Port
I/O Addressrange
IDEIO0
IDEIO1
Secundary (default)
170H-177H, 376H-377H
X
Tertiary
1E8H-1EFH
X
Quaternary
168H-16FH
Disabled
X
X
IRQ for CD-ROM - Ports (IDE_IRQ)
| | | | |
o o o o o o o o o o o o o o o o o o o o o o o o o
IRQ 15 IRQ 10 IRQ 11 IRQ 12 IRQ 14
Joystick Connector (X = Jumper present)
Joystick Connector
JYEN
Active (default)
X
Inactive
DRAM Expansion (X = Jumper present)
DRAM
DRAM_EN Pin
512KB DRAM (on card default)
2-1
SIMM present
3-2
Connector Pin Layout
Pin 1 Ground Pin 2 CD-Left channel in
Pin 3 Ground Pin 4 CD-Right channel in
CD Audio-Connector
Pin 1 CD-Left channel in Pin 2 Ground
Pin 3 Ground Pin 4 CD-Right channel in
PC Speaker Connector PC_SPK
Pin 1 +5Vdc Pin 2 PC Speaker Out
SPDIF Connector (Sony/Philips Digital Interface Format)
Pin 0 Digital Out Pin 1 Ground
Audio Extension Connector (JP20)
Pin 1 Speaker Ground
Pin 2 Speaker Right Channel
Pin 3 Speaker Left Channel
Pin 4 Speaker Out Feedback Left Channel
Pin 5 Speaker Out Feedback Right Channel
Audio Extension Connector (JP21)
Pin 1 Speaker Out, Right Channel
Pin 2 Speaker Out Feedback, Right Channel
Audio Extension Connector (JP22)
Pin 1 Ground
Pin 2 Microphone Input, Ground
Pin 3 Microphone Input, Left Channel (0.004 - 0.7 Vrms)
Diagnostic
There should exist a directory \SB16. Inside this directory
should be a file DIAGNOSE.EXE (if correct installed).
Start DIAGNOSE from a DOS prompt, and watch the output shown on display.
If there is a Token-Ring installed, you might have an address - conflict with
SoundBlaster set to default 220H address, change it to 240H and run DIAGNOSE.
AUTOEXEC.BAT (added lines, sample)
SET BLASTER=A220 I5 D1 H5 P330 E620 T6
SET SOUND=C:\SB16
SET MIDI=SYNTH:1 MAP:E MODE:0
C:\SB16\DIAGNOSE /S
C:\SB16\AWEUTIL /S
C:\SB16\SB16SET /P /Q
CONFIG.SYS (added lines, sample)
DEVICE=C:\SB16\DRV\CSP.SYS /UNIT=0 /BLASTER=A:220
C:\SB16\DRV\CTSB16.SYS /UNIT=0 /BLASTER=A:220 I:5 D:1 H:5
C:\SB16\DRV\CTMMSYS.SYS
Back to 
Feel free - send a 
for any BUG on this page found - Thank you.