Enable and Disable Settings (8573)

Enable and Disable Settings

To verify that the Enable and Disable settings are correct, select Set and View SCSI Device Configuration from the Set Configuration menu, and determine if there are any Presence Error Reporting devices listed. The settings must be as follows:

Devices connected to the computer must be set to Enabled .
Devices listed but not connected must be set to Disabled .

Change the settings by pressing F5, then save them by pressing F10.

Non-SCSI Devices

The missing device is defective.

If that does not correct the problem, go to 'Undetermined Problem'

NOTE: If the number of diskette drives shown on the list is incorrect, an error can occur during the tests. Restart the computer and verify that the drive information on the Set Configuration menu is correct, then continue testing.

Please see the LEGAL - Trademark notice.
Feel free - send a

for any BUG on this page found - Thank you.