Advanced Diagnostic Tests (3545)



Advanced Diagnostic Tests
  1.  Go to the advanced diagnostic screen by pressing Ctrl+A on the basic diagnostic screen.
  2.  Select Tool to install the tools.
  3.  Select a device, press the spacebar, and  install the tool. Multiple devices can be selected by repeating  this step.

  4.  A OK mark appears for the selected device.
  5.  Select OK and press Enter  if the selection is OK.
  6.  Select a device and press Enter to start the tests.


How to Run All Tests

In the advanced diagnostic screen, select Test All to test all devices.

How to Run the Loop Test

  1.  Go to the advanced diagnostic screen by  pressing Ctrl+A on the basic diagnostic screen.
  2.  Select the Looptest icon and press Enter or click  the click button.
  3.  Select a device and press the spacebar. A OK mark  appears for the selected device.
  4.  If the selection is OK, select OK and press Enter  to start the loop test.
  5.  To exit the loop test, press and hold Ctrl+Pause  until the interrupt is accepted by the test program.  A beep sounds when the interrupt is accepted.  The test loop stops at the end of the current test.


How to Run the Keyboard Test
  1.  Power-off the computer.
  2.  Remove the external keyboard, if one is attached.
  3.  Press and hold F1 key, then power-on the computer. Hold  F1 until the Easy-Setup screen appears.
  4.  Select Test and press Enter. The basic diagnostic  screen appears.
  5.  Press Ctrl+A to go to advanced diagnostic screen.
  6.  Press Ctrl+K. A keyboard picture appears  on the screen.
  7.  By pressing a key, the mark appears or disappears on  the corresponding key position on the screen.  Repeat this step for any keys that need to be tested.
  8.  To exit the test, press Esc or select the cancel icon.


How to Run the Audio Test
  1.  Power-off the computer.
  2.  Insert the maintenance diskette into  diskette drive A and power-on power.
  3.  Select the Audio Diagnostics from the main menu.
  4.  Select Tests from the menu bar and press Enter.
  5.  Select All tests from the pull-down menu and press Enter.

     Run options are set to test once and stop on error as defaults.  Other options can be selected by the pull-down menu of Setting-up.

  6.  Follow the instructions that  appear on the screen to proceed with the tests.
  7.  If the tests end without detecting any error,  the All tests passed OK message appears.
  8.  If an error is detected, the FRU code and error description message  appear.  Go to 'FRU Codes' and replace the FRU.
  9.  To exit the test screen, press Esc.

    NOTE:

    1.  If an instruction to plug the external loop cable  appears, connect it between the microphone/line jack of the computer  and the headphone jack of the Dock I.
    2.  If an instruction to plug the headphone appears,  connect it to the headphone jack of the Dock I.
    3.  Volume Control Test does not work when the  computer is docked to the Dock I.


PC Test Card LED

The green LED on the PC test card lights when the PCMCIA test is running. If the LED does not go on, check that the card is installed correctly by reseating the card. If it still does not light after reseating, try using another slot for the test. If the LED still does not go on and the test fails, replace the FRU shown in the diagnostic error code.

Back to  Jump to TOP-of-PAGE

Please see the LEGAL  -  Trademark notice.
Feel free - send a Email-NOTE  for any BUG on this page found - Thank you.