DASD Tray SCSI IDs/LED (Hot-Swap)

DASD Tray SCSI IDs/LED (Hot-Swap)

The SCSI IDs for DASD installed in the DASD Hot-Swap Tray Assembly (FRU P/N 06H3956) are set by the automatic configuration program for the computer.

When a drive is initialized, the LED (mounted on the back of the tray in which the drive is installed) should blink a few times and then stay on. Continuous blinking or failure of the LED to stay on might be caused by one of the following.

NOTE: Always run the diagnostic program for the computer you are servicing before replacing a FRU.

The tray is not seated properly
The computer is not configured properly
The tray, backplane, or drive is defective

Please see the LEGAL - Trademark notice.
Feel free - send a

for any BUG on this page found - Thank you.