Administrator Password (8650)
Administrator Password
If an administrator password is set, it must be entered
to use System Configuration Utility functions that allow you to change configuration
data. Before setting an administrator password, you must first
set the selectable drive-startup sequence, as described in
'Setting the Selectable Drive-Startup Sequence'
If an administrator password is set and then forgotten,
the password can be cleared from memory using a system board
configuration switch. Refer to 'Clearing All Passwords (Switch A6A1-2)' for more
information.
To set an administrator password in the Setup program do the
following.
- Start the Setup program.
- Select Set Administrator Password from the Security
Menu screen.
The Set Administrator Password screen appears.
- Type a password in the
Enter New Password data field.
NOTE:
To remove an administrator password, press Enter when
the Enter New Password data field is blank.
- Press Enter.
The cursor moves to the Confirm New Password data field.
- To verify that you typed the correct password, type the password
in the Confirm New Password data field.
If you did not type the correct password, you must re-enter the
password in the Enter New
Password data field. Return to step 3
- If you typed the correct password,
press Enter to save it.
The password becomes effective immediately after you save it.
Back to 
Please see the LEGAL - Trademark notice.
Feel free - send a 
for any BUG on this page found - Thank you.