User Password (8650)
User Password
A user password is not required but helps to protect the
information that is stored in the server and allows you to enable
secure mode. It also allows you to write-protect the boot sector
of a hard disk drive. Write-protecting the boot sector is a form
of virus protection.
If a user password is set and then forgotten, it can be
cleared from memory using a system board configuration switch.
Refer to 'Clearing All Passwords (Switch A6A1-2)' for more information.
To set a user password in the Setup program, do the following.
- Start the Setup program.
- Select Set User Password on the Security Menu screen.
The Set User Password screen appears.
- Type the password in the Enter New
Password data field.
- Press Enter.
The cursor moves to the Confirm New Password data
field.
- To verify that you typed the new password correctly,
type the password in the Confirm New Password data field.
If you did not type the correct password, you must re-enter the
password in the
Enter New Password
data field.
Return to step 3
- If you typed the correct password,
press Enter to save it.
The password becomes effective immediately after you save it.
Back to 
Please see the LEGAL - Trademark notice.
Feel free - send a 
for any BUG on this page found - Thank you.