Building a Hub Stack (8238)



Building a Hub Stack

To build a hub stack containing two or more hubs:
  1.  Mount or stack the hubs according to the following guidelines:

  2.  If you have not already done so, connect power to each hub.
  3.  Use a 2-foot IntraStack cable to connect IntraStack OUT on the mgmt hub  to IntraStack IN on the next hub above in the stack.
  4.  Using 2-foot IntraStack cables, continue to connect IntraStack OUT on each hub  to IntraStack IN on the next hub above in the stack.
  5.  Complete the loop by using the 4-foot IntraStack cable to connect IntraStack OUT  on the top hub to IntraStack IN on the mgmt. hub.
  6.  Check the LEDs to verify proper operation.
     The Stack IN and OUT LEDs on each hub:

     For more information, refer to the section 'Interpreting Hub LEDs'.

 


Back to  Jump to TOP-of-PAGE

Please see the LEGAL  -  Trademark notice.
Feel free - send a Email-NOTE  for any BUG on this page found - Thank you.