(6588) 6888 - Pentium® II 266/300MHz System Board



1 Display Connector
2 Ethernet RJ45 Connector
3 Infrared Connector (J3M1)
4 USB (Universal Serial Bus) 2 Connector

5 Serial Port System Board Connector (J4M1)
Serial Port A Connector located on back of chassis)

6 USB (Universal Serial Bus) 1 Connector
7 Parallel Port Connector
8 5 Vdc Auxiliary Connector (J6N2)
9 Mouse Connector
10 Keyboard Connector
11 Audio Line Out
12 Audio Line In
13 Tela Jack Audio (J9M3)
14 Diskette Drive Connector (J8L1)
15 CD-ROM Connector
16 Wave Table Audio (J1K1)
17 Primary IDE Connector (J9J1)
18 Secondary IDE Connector (J9J2)
19 System Board Jumper Block (J8H1)
20 Power Connector (3.3 Vdc)
21 Main Power Connector
22 Boot Block Recovery Jumper
23 Chassis Security Connector
24 Microprocessor Socket (U5C1)
25 Power Switch Connector (J3A1)
26 Power LED/Hard Disk LED Connector (J2A1)
27 Fan Connector (J1A1)
28 DIMM Connectors 0-1-2 (J2D2 J2D1 J1D2)
29 SCSI Activity LED Connector (J1F1)
30 Wake-Up on LAN (WOL) (J3F1)
31 Modem Wake-Up (J3G1)
32 Battery
33 Feature Connector
34 Riser Card Connector (J6J1)

  See > System Board Memory
for DIMM size, speed, and type.

Supported Memory Configurations
Any combinations of DIMM sizes is acceptable. DIMM height must not exceed 1.2 inches. If EDO NP (non parity) DIMMs and EDO ECC DIMMs are mixed, they will configure as non-parity. Install only EDO ECC DIMMs to enable parity.

Back to  Jump to TOP-of-PAGE

Please see the LEGAL  -  Trademark notice.
Feel free - send a Email-NOTE  for any BUG on this page found - Thank you.