Pentium® II-Klamath (socket 1) - CPU Connector
Microprocessor Removal Type 6588, 6888
- Remove Airflow Cover.
- Push in the two Tabs, until Tabs release.
- Carefully place one hand on the system board and pull the microprocessor
up and out of the connector with the other hand.
When replacing the system board, keep the following:
- Retention Bracket
- System Board Plate
- Screws and Washers
Make sure the plastic washers are attached
to the six mounting tabs of the system board plate, and that the washers are under the two front screw
heads that secure the system board plate.
If any of the washers are not installed (as shown), the system board can be damaged.