2163 and 2164 - Aptiva - System Board Jumpers and Connectors
The blackened pin of a jumper represents pin 1.
DIMM Configurations
A maximum of 384MB memory may be installed.
You can install 16MB, 64MB, or 128MB PC-100 SDRAM-DIMM (64-bit, non-ECC, 100MHz, 3.3volt, gold contact) in any sockets and
with any combinations.
See > BIOS Setup Utility - Memory/Cache Options
When checking voltages, the power supply fan must be running.
To power-on the power supply without using the on/off switch, use a screwdriver
or other tool to short the connector CN9 pins (with the switch cable
disconnected from the connector on the system board), or use a connection (jumper) to
short the black and green wires of the 20-pin connector (pin 14-15) on power supply.