Index of Symptoms, Messages, Error Codes, or Beeps - Aptiva (SL-A) 2158, 2163
Index of Symptoms, Messages, Error Codes, or Beeps
How to Use Error Messages: Use the messages, error codes, and beeps
combinations that occur to diagnose failures. If more than one failure occurs,
begin the diagnosis from the first failure that appeared. The cause of the first
failure can result in false messages, error codes, or beeps. If you did not
receive any messages, error codes, or beeps, see if the symptom is listed in
'Error Symptoms List'
-CAUTION- When you have deemed it necessary to replace a FRU, and have
done so, you must run a total system check to ensure that no other
activity has been affected by the change. This system check can be
done through the diagnostics program (Select Diagnostics, then select
and execute All Tests from PC-Doctor).
POST: Some diagnostic aids are resident in the machine, such as the Power-On
Self Test (POST).
The machine performs the POST each time it is powered
on. Use this information throughout the diagnostic procedures. The POST is a
series of system checks and initializations that verify the correct operation of
the base system.
After a successful POST, the system attempts to load operating system. The
system can be customized for different startup (boot) methods by the BIOS
Setup Utility. See 'Startup Options'
The system's default startup sequence automatically looks for the operating
system files in the hard disk if these files are not found in the diskette.
Remember that POST does not test all areas, but only those that
allow the system to operate well enough to run the diagnostics program.
The most likely cause is listed first. Make sure you
complete all items in the cause or 'Action/FRU' column. When servicing a
system, always begin with 'Start'
If you are unable to correct the problem using these two index tables, go to
'Undetermined Problems'
NOTE:
- If an error message and incorrect audio response occur, diagnose the error message first.
- If you cannot run the diagnostics program tests but did receive a POST error code and message,
use 'POST Error Codes and Messages List' to diagnose system problems.
- If you cannot run the diagnostics program tests but did receive a POST error
beeps, use 'BIOS Error Beeps List' to diagnose system problems.
- If you did not receive any error message, look for a description of the error
symptoms in 'Error Symptoms List'
-IMPORTANT- Check all power supply voltages, switch, and jumper settings
before you replace the system board. Also check the power supply
voltages if you have a 'system no-power' condition.
- If you are unable to correct the problem by using the 'BIOS Error Codes,
Messages, And Beeps List' table and 'Error Symptoms List' table, go to
'Undetermined Problems'
Back to 
Please see the LEGAL - Trademark notice.
Feel free - send a 
for any BUG on this page found - Thank you.