Aptiva 2139 System Board Layout


Aptiva 2139 System Board Connector and Functions

Connector Function Connect to..
CN1 ATX power connector Power supply
CN2 Universal Serial Bus (USB) connector USB device
CN3 Upper: PS/2 mouse connector
Lower: PS/2 keyboard connector
Keyboard
Mouse
CN4 Upper: Printer port (25-pin female)
Lower: Serial port 1 (9-pin male)
Video port (15-pin female)
Printer
Serial device
Monitor
CN5 Upper: MIDI connector
Lower: Mic-in/Line-in/Line-out connectors
Joystick
Speaker,
Microphone
CN6 IDE LED connector
Connect the red wire to pin-1, white
wire to pin-2, then leave pin-3, -4 as
non-connected; or connect the red wire
to pin-4, white wire to pin-3, then leave
pin-1, -2 as non-connected.
Hard drive LED
CN7 ATI media connector (AMC) Reserved
CN8 Modem/Line-in connector Modem card
CN9 CD/DVD audio input connector CD/DVD-ROM drive
CN10 Modem wake up on ring connector Modem card
CN11 Diskette drive connector Diskette drive
CN12 Primary IDE connector Hard disk drive
CN13 Secondary IDE connector Hard disk drive
CN15 CS4610 adapter feature connector Reserved
JP4 Power LED connector
Connect the green wire to pin-1,
white wire to pin-3.
Power LED
FN1,2 Processor heat-sink fan connector Processor fan


2139 System Board Jumper Settings

  Jumper/Settings           Function
 -------------------------|------------------------------
  J1                      | Audio Resource Protection
   1-2                    |   Write Protected
   2-3                    |   Programmable
 --------------------------------------------------------
  JP2                     | VGA IRQ
   1-2                    |   Disable IRQ
   2-3                    |   Enable IRQ
 --------------------------------------------------------
  S1, SW-1                | Host Bus Clock Selection
   On                     |   66 MHz
   Off *                  |  100 MHz
 --------------------------------------------------------
  S1, SW-2                | Password Check
   On                     |   Bypass password
   Off *                  |   Check password
 --------------------------------------------------------
  S1, SW-3, SW-4          | Reserved
 --------------------------------------------------------
  S1, SW-5 SW-6 SW-7 SW-8 | Slot1 Core/Bus Clock Ratio
      On,  On,  On,  On   |   2
      On,  Off, On,  On   |   3
      Off, On,  On,  On   |   4
      Off, Off, On,  On   |   5
      On,  On,  Off, On   |   5/2
      On,  Off, Off, On   |   7/2
      Off, On,  Off, On   |   9/2
      Off, Off, Off, On   |  11/2
 --------------------------------------------------------


DIMM Configurations

A maximum of 384 MB memory may be installed.
You can install 16MB, 32MB, 64MB, or 128MB PC-100 DIMM in any sockets and with any combinations.


Back to  Jump to TOP-of-PAGE

Please see the LEGAL  -  Trademark notice.
Feel free - send a Email-NOTE  for any BUG on this page found - Thank you.