Setting Up Responses without SNMP Automation Control Installed


Setting Up Responses without SNMP Automation Control Installed

Without SNMP Automation Control installed, the network administrator can set up custom responses to SNMP traps.
Use the following procedure to setup custom responses to SNMP traps in NetView:

  1.  From the NetView Console, click on Options, then double-click on Trap Settings.
  2.  Select the Enterprise IBM_Universal_Management.
  3.  Select one of the Traps and edit its properties.
  4.  Into the box labeled Run this command when the trap is received, enter your own command.


Note that you have access to information from the SNMP trap. This information is specified as $1, $2, and so on.

Please see the LEGAL  -  Trademark notice.
Feel free - send a Email-NOTE  for any BUG on this page found - Thank you.