AMD K6-2XT Processor - (Aptiva 2170 - SL-A)

AMD K6-2XT Processor (for 2170)

NOTE: Determine the type of processor you are installing and make sure the jumpers are set correctly.
Run the Setup Utility after correctly installing a processor.

  -CAUTION- Processors are sensitive to static discharge.

•  Remove adapter cards if applicable.
•  Detach the heat sink cable from the fan connector.
•  Remove the fan sink by pressing the release tab (rectangular end) and lifting it up from the Processor.
•  Pull up the ZIF socket release lever.
•  Lift the processor out of the socket.

•  Place the ZIF socket release lever to the release (up) position.
•  Insert the new processor, matching the notched corner of the processor with the pin 1  indicator on the socket.
  
•  Push down the lever to lock the processor to the socket.
•  Place the processor heat sink fan over the processor.
•  Insert one side of fan brace onto the ZIF socket.
•  Secure by latching the other side to the ZIF socket.
•  Reconnect the processor fan sink cable to the connector FN1 on the system board.