Systems requiring manual PCI adapter configuration

  Chapter 4. Systems requiring manual PCI adapter configuration
    Some systems are electrically and physically PCI compatible,
  but require manual re-configuration when adding PCI adapters.
  Repeated here are the required resources (As listed in the
  Auto LANStreamer PCI Installation and Testing Manual, Chapter 2,
  page 15.)  Some systems may only require that a few of these
  parameters be set manually.
  The Auto LANStreamer PCI adapter requires these resources:
  - Adapter Enable = ON
  - Bus Master Enable = ON
  - I/O Location - any available 256-byte address range.
  - Memory Location - any available 256-byte address range.
  - Interrupt - Any available interrupt except 0 (INT0)
                (see Interrupt section below)
  - ROM Location - Any available 16K-byte ROM address range.
                (see ROM mapping section below)
  - Latency timer - Any value
                (see performance section below)
                         -----------------
    System error message clarification:
  1)  WARNING: Insufficient PCI Memory Block
      Use Setup to increase the PCI Memory Block Size.

     -This was seen on one Gateway2000 system when too much
      'Shadow ROM' had been disabled from the system setup
      utility.  To correct this problem, follow the instructions
      in the system's user manual to properly configure any
      required ISA adapter ROM space utilization.  Leave remaining
      ROM address ranges enabled for use by the PCI devices.
     -The Auto LANStreamer uses 16K bytes of ROM space (located
      somewhere between 'C0000'h and 'DFFFF'h) for its Remote IPL
      code.  At least 16K must be available for each Auto
      LANStreamer PCI adapter in the system.


Back to  Jump to TOP-of-PAGE

Please see the LEGAL  -  Trademark notice.
Feel free - send a Email-NOTE  for any BUG on this page found - Thank you.