IBM-DOS V-7.0 -M- ERROR Messages

 Maximum number of Logical DOS Drives installed 
    Cause:    FDISK.  DOS supports only drive letters A through Z.  You have created the maximum number of logical
              drives (24).
    Action:  If you need to define a new logical drive, you must first delete an existing logical drive to free a drive
              letter.
  Memory allocation error
 Cannot load COMMAND, system halted 

    Cause:    DOS.  A program destroyed the area in which DOS keeps track of available memory, or there is no
              longer enough memory to load the command processor.
    Action:  Restart PC DOS on your system. Reducing the number of buffers, device drivers, and resident programs
              on your system might alleviate this error.
 Memory control blocks destroyed 
    Cause:    COMMANDS.  PC DOS detected a memory problem.
    Action:  Restart your computer.
 Missing operating system 
    Cause:    FDISK.  When you tried to start PC DOS from a hard disk, the startup procedures determined that the
              DOS partition was marked "startable," but the disk does not contain a copy of PC DOS.
    Action:  Start PC DOS from the Setup diskette of your installation diskettes and use FORMAT with the /s switch
              to place a copy of PC DOS on the hard disk.  Back up your files before doing the FORMAT or they will be lost.
 Must enter both /T and /N switches 
    Cause:    FORMAT.  You have entered either the /t or /n switch by itself.
    Action:  These switches must be entered together. Re-enter the command using both switches.
 Must have xxxxxx KB free to continue the operation 
    Cause:    UNCOMP or SDEFRAG.  The program has determined that there is not enough free space available to
              complete the operation.
    Action:
    1. Write down the number of KBs needed.
    2. Exit to the DOS prompt.
    3. Run CHECK x:/d on the drive, where x: is the compressed drive.
    4. Note the physical free space.  This is the number to which UNCOMP/SDEFRAG refers.  The physical free space
       is listed under the column of data about the STACVOL.
    5. Delete or move files from the compressed drive and use CHECK to verify that enough physical free space is
       there to continue the UNCOMP/SDEFRAG operation.
 Must specify COM1, COM2, COM3 or COM4 
     Cause:    MODE.  You incorrectly entered MODE option 4.
     Action:  Retry using correct option.


Back to  Jump to TOP-of-PAGE

Please see the LEGAL  -  Trademark notice.
Feel free - send a Email-NOTE  for any BUG on this page found - Thank you.