WARNING! COM assignment conflict with system COM
Cause: PCMCIA. The COM port you specified for PCMCIA is already being used by another device.
Action: Use PCMSETUP to assign a COM port that is not being used.
WARNING! Command line parameters ignored
Cause: PCMCIA. Parameters were specified at the command line or in the CONFIG.SYS file. Parameters cannot
be specified anywhere except the PCM.INI file.
Action: Remove all PCMCIA parameters from your CONFIG.SYS file or command prompt. Edit your
PCM.INI file and supply the needed parameters or rerun PCMSETUP.
WARNING 'include' specifies memory already excluded at yyyy
Cause: PCMCIA (PCMRMAN). yyyy is the address in hexadecimal. The same memory region was included and
excluded in the PCM.INI file.
Action: Run PCMRMAN to correct the address ranges in conflict.
WARNING! No files were found to restore
Cause: RESTORE. The specified files could not be found on the backup disk.
Action: Make sure you typed the file names correctly, and that the files exist.
WARNING! No partitions are set active - disk 1 is not
startable unless a partition is set active
Cause: FDISK. Your system does not have an active primary partition. You cannot start your computer from
the hard disk without an active primary partition.
Action: To set an active partition, choose option 2, Set active partition, from the FDISK main menu.
WARNING! The partition set as active is not startable
Cause: FDISK. The partition set active does not contain the system files.
Action: Make sure the IBMDOS.COM, IBMBIO.COM, and COMMAND.COM files are present in the primary DOS partition.
WARNING! USECARDS error. Processing PCM.INI discontinued
Cause: There is a syntax error in the specification of the card configurations to to load.
Action: Correct the syntax error of the USECARDS keyword in the PCM.INI file.
WARNING! Write caching is not available on the CD-ROM drive
Cause: SMARTDRV. You have tried to activate write caching on a drive that is assigned to your CD-ROM.
Action: Check your command specification and re-enter with the correct drive letter.
Write failure, diskette unusable
Cause: COMMANDS. The destination disk cannot be used.
Action: Specify a different destination disk.
Write fault error
Cause: COMMANDS. You specified a device that is not assigned in your system, or the device is not connected
Action: Make sure that the device is properly connected and installed in your system, and that you typed the
command with the correct device specification.
Write protect error writing drive x:
Cause: An attempt was made to write to a write-protected diskette.
Action: Investigate carefully before you decide to write to a write-protected diskette.
Please see the LEGAL - Trademark notice.
Feel free - send a for any BUG on this page found - Thank you.