Alarm/Wakeup Settings (Server 330)
Alarm/Wakeup Settings
The server can be started manually or at a predefined
event. The server enters one of the following states.
Standby mode
The server is powered down.
The automatic restart feature, which enables the server to restart
following a momentary power loss, means that the server is
never completely powered off.
The server must be in the Standby mode (off) for the
Alarm/Wakeup Settings features that you define to take effect.
Attended mode
This is the 'on' state that occurs when you press
the power switch from the Standby or Unattended mode.
The Power-On Light comes on whenever the server is on.
Unattended mode
The server starts at a specified date and time, or when
it receives a signal from either serial port.
When the server powers on in the Unattended mode, the Unattended Power-On
light and the Power-On Light come on.
NOTE: To change from Unattended mode to Attended mode, press
the power switch. Press the power switch again to change to Standby mode.
Select the Alarm/Wakeup Settings choice
to enable and disable the Unattended mode.
NOTE:
- Set the Wakeup features immediately before you plan to power-off the
server. The server locks and cannot be used after you exit, saving the
settings. When the server restarts, in either Attended or Unattended mode,
the Wakeup features return to the default, disabled, setting.
- When both features are enabled, the server starts when the first
condition (time or signal) occurs.
The Alarm/Wakeup Settings choice appears only
on the full Configuration/Setup menu.
Back to 
Please see the LEGAL - Trademark notice.
Feel free - send a 
for any BUG on this page found - Thank you.