Printer (3547)


Test the printer by connecting it to the computer before testing it on the SelectaDock Docking System.
  1.  Make sure the printer is  correctly connected and the power is turned on.
  2.  Run the printer self-test.

If the printer self-test does not run correctly, the problem is in the printer. Refer to the printer service manual.
If the printer self-test runs correctly, connect a wrap plug on the parallel connector on the rear of SelectaDock Docking System and run the advanced diagnostic tests to determine the failing FRU.
If the advanced diagnostic tests (with the wrap plug connected) did not detect a failure, replace the printer cable.
If the problem is not corrected, do one of the following:

Back to  Jump to TOP-of-PAGE

Please see the LEGAL  -  Trademark notice.
Feel free - send a Email-NOTE  for any BUG on this page found - Thank you.