User Password (Netfinity 7000 - 8651)

User Password

A user password is not required, but a user password helps to protect the information stored in the server. It allows you to enable secure mode and write-protect the boot sector of a hard disk drive. Write-protecting the boot sector is a form of virus protection.

If a user password is set and then forgotten, you can clear the password from memory using a system-board configuration switch.

To set a user password in the Setup program:
  1.  Start the Setup program.
  2.  Select Set User Password on the Security Menu screen.  The Set User Password screen appears.
  3.  Type the password in the Enter New Password data field.
  4.  Press Enter.
     The cursor moves to the Confirm New Password data field.
  5.  To verify that you typed the new password correctly,  type the password in the Confirm New Password  data field. If you did not type the correct password,  you must reenter the password in the Enter New  Password data field.
  6.  If you typed the correct password, press Enter to save it.

The password becomes effective immediately after you save it.

Back to  Jump to TOP-of-PAGE

Please see the LEGAL  -  Trademark notice.
Feel free - send a Email-NOTE  for any BUG on this page found - Thank you.