Power Backplane Removal (Netfinity 7000 - 8651)

Power Backplane Removal

  Caution Hazardous voltage, current, and energy levels are
present inside the power backplane.

To remove the power backplane assembly, do the following:

  1.  Power-off the server and all attached devices and  disconnect all external cables and power cords.
  2.  Loosen the 4 screws at the rear of the Central  Electronics Complex (CEC) and slide it back.

  3.  Remove the air baffle -1-

    NOTE: If the air baffle is not installed correctly, the  server will overheat.

  4.  Remove the power supplies, see 'Hot-Swap Power Supply Removal'
  5.  Remove the 5-volt voltage regulator card, see '5-Volt Regulator Card'.
  6.  Remove the AC power assembly, see 'AC Power Assembly'.

     1 Power Backplane Cover Screws
     2 Power Backplane Cover
     3 Back Plane Screws
     4 Back Plane

  7.  Disconnect the cables from the power backplane
  8.  Remove the 2 power backplane cover screws -1- and  remove the power backplane cover -5-
  9.  Slide the CEC back into position.
  10.  Remove the 10 power backplane screws -3- and  remove the power backplane -4-

Back to  Jump to TOP-of-PAGE

Please see the LEGAL  -  Trademark notice.
Feel free - send a Email-NOTE  for any BUG on this page found - Thank you.