System (Planar) Board (Netfinity 7000 - 8651)

System (Planar) Board

1 Power control and status cable
2 +5V, +12V, and 3.3V power connectors (identical)
3 Diskette-drive connector
4 Front-panel connector
5 IDE connector
6 Memory-board connector
7 Not used
8 Secondary processor-board connector
9 Primary processor-board connector
10 Fan 1 connector (not used, jumper required)
11 Fan 2 connector (not used, jumper required)
12 Hard disk drive LED 1 connector
13 Not used
14 Not used
15 Server management connector
16 IC2
17 Fan 3 connector (not used, jumper required)

18 Fan 4 connector
(jumper required unless optional thermal upgrade kit is used)

19 Hard disk drive LED 2 connector
20 SCSI channels A (right) and B (left) connectors
21 EISA/ISA slots 1-4 for adapters
22 Not used
23 PCI slots 1-6 for adapters

24 Configuration Switches and Jumpers (S6Ax - J6Ax)

•  Enabling BIOS Recovery Mode (J6A1)
•  BIOS Boot Block Jumper Setting (J6A1)
•  Video-Sleep-Register Address Setting (J6A2)
•  BIOS Write Jumper Setting (J6A4)
•  NVRAM and RTC Settings (Switch S6A1-1)
•  Clearing All Passwords (Switch S6A1-2)

NOTE: The SCSI-A controller is cabled to hot-swap bank B, the SCSI-B controller is cabled to hot-swap bank A.

Please see the LEGAL  -  Trademark notice.
Feel free - send a   for any BUG on this page found - Thank you.