System Board Removal

System Board Removal


  1.  Read 'Safety Information'.
  2.  If possible, record the configuration settings  before removing the system board (see 'Configuration/Setup Utility Program').

To remove the system board, do the following:

  1.  Turn off the server and peripheral devices and disconnect all external cables  and power cords (see 'Preparing to install options'), then  remove the top cover (see 'Top Cover Removal').
  2.  Disconnect all adapter cables and remove the  adapters (see 'Adapters'  and 'Hot-plug PCI adapter installation').
  3.  Remove the adapter dividers.
    1.  Press on the adapter divider release tab -1- and  lift the divider out of the system.
    2.  Repeat the procedure for each adapter divider.

  4.  Remove the processor board (see 'Processor Board Removal').
  5.  Disconnect all system board cables.
  6.  Remove the processor card support tray housing.
    1.  Remove the processor card support tray  housing screws -1-.
    2.  Lift the support tray housing latches -2- to  release the housing from the shuttle, then, lift the  housing out of the system.

  7.  Remove the system board dust cover -1-.
  8.  Remove (10 screws) the system board.
  9.  Remove the system board mounting screws,  then, remove the system board.

Back to  Jump to TOP-of-PAGE

Please see the LEGAL  -  Trademark notice.
Feel free - send a Email-NOTE  for any BUG on this page found - Thank you.