RAID Configuration Commands
The IPSSEND RAID configuration commands include the following:
DRIVEVER Use the DRIVEVER command to display the vendor ID, microcode version, and serial number of a SCSI device.
The IPSSEND program retrieves this information directly from the device.
Supported operating systems: Windows NT, OS/2, NetWare, OpenServer, UnixWare, and DOS
Command: IPSSEND DRIVEVER Controller Channel SID
Replace:
GETCONFIG Use the GETCONFIG command to display the ServeRAID adapter or controller configuration information.
This includes information about the firmware version; initiator ID and rebuild rate; logical drive status, RAID level, and size; and physical
device type, SCSI ID, and PFA error.
Supported operating systems: Windows NT, OS/2, NetWare, OpenServer, UnixWare, and DOS
Command: IPSSEND GETCONFIG Controller Options
Replace:
HSREBUILD Use the HSREBUILD command to set the ServeRAID adapter or controller hot-swap rebuild
feature on.
Use a question mark (?) to display the current status of the hot-swap rebuild feature.
Supported operating systems: Windows NT, OS/2, NetWare, OpenServer, UnixWare, and DOS
Command: IPSSEND HSREBUILD Controller Options
Replace:
Please see the LEGAL - Trademark notice.
Feel free - send a for any BUG on this page found - Thank you.